2016 Tesla Model X Pyrotechnic Pyro Fuse Replacement Location Tesla No description has been added to this video. Remove the pyrotechnic fuse from the vehicle. installation procedure is the reverse of removal. remove remove the glove box (refer to procedure). remove the cabin filter cover. remove the cabin filter. note: some vehicles are equipped with a hepa filter element bonded to the filter housing.
Tesla Model S And X Pyro Fuse Replacement Battery Tlm 1530 Sold As A Position the hybrid pyro fuse with the embossed arrow pointing rearward, and then install the fuse into the fuse cavity past the tabs (x4) that retain the fuse. The fuse box is located under the maintenance panel in the front trunk. remove the access panel by pulling it upward to release the clips that hold it in place. Fuse box diagrams for tesla model x (2016, 2017, 2018, 2019, and 2020), including the location of blocks, a list of fuses and relays, and their assigning. Fuse is located below the high voltage battery. it will take around 0,54 hrs to replace & will cost labor around 115 150. labor cost could vary depend on type of workshop, location etc. it will take longer to replace fuse for car with battery 1.0. fuse is located on top of the high voltage battery.
Tesla Model 3 Pyro Fuse Replacement Electude Fuse box diagrams for tesla model x (2016, 2017, 2018, 2019, and 2020), including the location of blocks, a list of fuses and relays, and their assigning. Fuse is located below the high voltage battery. it will take around 0,54 hrs to replace & will cost labor around 115 150. labor cost could vary depend on type of workshop, location etc. it will take longer to replace fuse for car with battery 1.0. fuse is located on top of the high voltage battery. This document provides instructions for removing and replacing a pyrotechnic fuse in a vehicle. it warns that the driver's door glass must be fully open before disconnecting power to avoid lockout. In this video i show the replacement procedure for a pyrofuse in a tesla battery system, this is required after a crash when the restraint module sends a signal to open the fuse to shut. Remove and discard the bolts (x8) that attach the pyrotechnic fuse cover to the hv battery, and then remove the cover. clean the sealing surface of the pyrotechnic fuse cover with an ipa wipe, and allow 1 minute to dry. It’s the old version of the pyro fuse that rans out of charge and it needs replacement. i submitted a service request, but i just want to know if anyone had this happened before and if it was covered under the battery warranty?.
Comments are closed.